r/FixMyPrint • u/Ok-Phase9141 • 1d ago

Fix My Print Vase gone wrong

When it went.to.the smaller part it startes that.

Bambu lab A1 Combo

Noozle 0.8

External wall 1mm

170mm height

Spiral vase on

Brim on

Temperature 245 C

Minimun speed 10mm

Fan 30%-50% (30s-12s)

Layer h 0.32

Filament PETG Masterprint

Plate PEI golden (standard)

Plate temp 80 C

2 Upvotes

76% Upvoted

3 comments sorted by

•

u/AutoModerator 1d ago

Hello /u/Ok-Phase9141,

As a reminder, most common print quality issues can be found in the Simplify3D picture guide. Make sure you select the most appropriate flair for your post.

Please remember to include the following details to help troubleshoot your problem.

  • Printer & Slicer
  • Filament Material and Brand
  • Nozzle and Bed Temperature
  • Print Speed
  • Nozzle Retraction Settings

Additional settings or relevant information is always encouraged.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

1

u/Similar_Interview225 1d ago

If the problem starts right where the vase narrows, I'd first check the slicer preview at that height: does each loop suddenly take much less time? With PETG in spiral vase mode, the nozzle can come back before the previous loop has cooled. In Bambu Studio, try enabling/raising the filament's minimum layer time (slow down for better layer cooling), then print a small test of just that section. A photo of the defect and the speed/layer-time preview would help tell whether it's heat buildup or a flow issue.