r/3Dprinting • u/averagejjbaenjoyer69 • 5h ago

Troubleshooting My Mom Needs Help with This.

Post image

My mom asked me to make a post asking for help with her 3d printer. I don't know much about it myself so if you have any questions I can relay them to her and reply.

My mom has a Bamboo labs X2D. She's using Bamboolabs transparent real PLA. Temps were the Bamboolabs automatic settings. Outer wall 50 inner walls 200. She was using Bamboolab software.

Used glue stick on the bed because we were having adhesion problems. First couple of layers were fine, walked away, came back hours later, was a 55 minute print, bamboolabs said it was completely, only to return to see this. How can I get this off? Can I heat the nozel independently to pull it off?

0 Upvotes

33% Upvoted

16 comments sorted by

View all comments

2

u/MagnusPerditor 5h ago

You don’t need a glue stick for normal filaments with modern printers. Heat up the nozzle and clean it off carefully.

Also lord. It’s bambulabs.

1

u/averagejjbaenjoyer69 5h ago

She was having trouble with the prints sticking previously, that's why she used glue. Thank you.

and I'm sorry, she didn't tell me how to spell it. I'm not into these kinds of things, I just wanted to help her. 🙁

2

u/MagnusPerditor 5h ago

Yeah that’s a settings issue and without those, we can’t say why it happened.

0

u/averagejjbaenjoyer69 4h ago

She said it was the default settings but I'm not too sure. I'll tell her to check her settings again and adjust them. Thank you. :)